Simpson Cleaning 3400 PSI Gas Pressure Washer, 2.5 GPM Power Washer for Residential Use, CRX Engine, 25-Foot MorFlex Hose, Clean Machine, 49-State (CM61083)

My husband loves it! We have noticed that he has to change the oil quite frequently but it could be because he uses it daily.

Works very well, i recommend you!!Jala bien chingon charros se las recomiendo!!

So out of the box this washer is pretty basic - no accessories other than 4 nozzles. I added some stainless steel quick disconnects, a 50 foot hose extension, a cheap foam cannon, the Simpson in-line pressure regulator, and a 15 inch surface cleaner.This is a bargain and worth every penny even without those accessories. The power is amazing. The engine started on the second pull. It is relatively quiet for a gasoline engine. I ran it through 2.5 gallons of gasoline in about 4 hours of continuous operation with zero issues.There is some preparation required before the first use - the big one is you need to add oil - which is included in a pre measured pouch - to the engine crankcase Do this before putting any gasoline in the tank and give the engine several pulls to lubricate things. Also, before you start the engine, connect the pump to the supply hose and turn on the water. Remove the nozzle from the spray wand and squeeze the trigger to purge and prime the pump and high pressure hose - this can take a few minutes to fully purge out the air. Once purged, make sure their is gasoline in the tank, the throttle is open, the fuel valve is open, the choke is closed, the kill switch is on and give the starter a pull. Once the engine has started, pull the spray wand trigger again to fully purge the pump. It may look and feel like the pump has low pressure - keep squeezing the trigger and give it a minute. You will hear the engine bog down and suddenly there is pressure. Add the spray nozzle and go to work!The only issue I had was mounting the spray wand holder. It he mounting hole is partially blocked by the “apron” between the handles. I had to loosen the Torx screws of the apron to get enough clearance for the bolt to go in the hole. Once it was through, the apron screws could be tightened up again. And the holder holds the wand very securely if you insert it and twist it to snap it in place. Maybe the newer machines have a redesigned holder based on other reviews stating the holder was “worthless”.Based on my experience so far, I would recommend this machine - it is more than adequate for home use. The build quality is very good, the frame is strong, the engine is great, and the performance is awesome. Hopefully it lasts years with moderate use.

Ok it does vibrate alot.but it does have good pressure way more than an electric washer does.dont put your hands in front of the nozzle it will cut you.you can pressure wash a 2x6 pine board and if close to it it will peel the lumber.i don't know how long it will last but ive used it 3 x.starts easy. Motor stays running fast when thou let of the handle of the wand.when pressed again builds pressure very fast. If you have decals on your car don't get to close;it will peel off stickers as well .

I have not started it yet. The quick start guide is for a number of different models so stuff marked important was not even on my pump (as I found out later). I called product support and they basically look at the available parts and have no idea what the machine looks like or where stuff is suppose to be. I asked how you adjust the water pressure and they did not know at all. I was quite disappointed. The engine has a hole where Honda engines typically have a plug for draining the oil. Product support could not tell me anything about this, and the plug was missing. I finally called a local pressure washer service company and they were very kind and told me which parts were not on my pump and that this oil drain hole on the engine was actually plugged and would not leak, it was just part of the casting. You can only adjust the water pressure by changing nozzles, there is no adjustment on the pump, itself. The hose and gun and wand are VERY CHEAP and will be a pain to use. Finally, I learned from the service person that Simpson licenses the ability to label the gas engine as a Honda engine, but Simpson makes the engine and it is not the same quality at all.Update after using it for a few hours. The product description that this is 3200 psi is misleading. With the fan shaped nozzles you always use, it is more like 2200 psi. It would not remove moss and some dirt from my driveway with the green nozzle. It would not power a 14" rotary surface washing attachment, not even close to enough pressure. I would return it but I have probably used it too much.

Excelente maquina. Han pasado varios años desde que la compre, la utilizo (ahora no tanto) pero me ayudo a salir en mi negocio de wash and detailing y aun me funciona. Cómodo precio y no me arrepiento de la compra. Y aun no tiene liqueo de aceite. (Aclaro q siempre yo le hago los mantenimientos).

Amazing power sprayer for the price. Was able to do whole two car driveway with ease. Worth it just for that job alone.

Started Up on the First Pull!!good price and operates great