Hose Clamps, Hose Clamp Box of 10, Radiator Hose Clamp, Silver, Size SAE 28

This hose clamp is well made and of good quality stainless steel. I would consider it to be a heavy duty clamp as compared to the ones sold at the local hardware store. The hex head is larger than most other clamps of this size and also has a screwdriver slot for tightening the clamp. I used a ratchet to tighten the clamps and was able to apply considerable torque without damaging the clamp. I'm very pleased with the quality of this hose clamp.

These are high quality hose clamps; wide with a large screw. I purchased a couple boxes of #10's; use them a lot.

You can't beat these for the price. And the availability. Good fit with the correct size.

This fairly review applies only to SAE 10 clamps. I have these Koehler brand clamps in several sizes. The SAE 10 that I recently purchased are working fine but have a shorter worm drive housing compared to the higher end Ideal / Ideal - Tridon clamps. In general, the biggest difference between this brand and the Ideal clamps is in the worm drive housing. It's a little bit more robust in the Ideal clamps. The metal type used in the housing and screw also appears to be different. I don't think the Koehler clamps use SS for the housing or screw. Regardless, I haven't had any issues with these clamps in this size or any other and I look for this brand if I'm looking to purchase several to have on hand as, in my experience, they are better than some of the off-brand clamps that I have come across. But it is notable that the SAE 10 clamps have a shorter worm drive housing which logically translates to the possibility of a shorter worm drive gear and therefore, potentially, less secure clamping than the Ideal or other more highly regarded brands. In the other sizes of clamps that I have in this Koehler brand, the worm drive housings are about the same length as those of the Ideal / Ideal-Tridon clamps that I have. Again, I did not have any issues with these clamps in terms of performance however, for peace of mind if for nothing else, I did replace this SAE 10 size Koehler clamp with an Ideal brand clamp in one, very critical application.

These are great screw drive clamps. I used for installing a radiator hose in my car. It can be opened up to slip on a radiator hose by loosening the screw with a screwdriver or socket wrench and tightened in place after you re-position it. Much easier to work with than spring clamps and seems to provide a better seal.. Material is stainless steel so it is strong and should last a long time. Highly recommend!

I've had many clamps that strip when attempting to tighten, these are very sturdy and functioned as expected.

Decent hose clamps. Nothing wrong, nothing super fancy, just good hose clamps.

Purchase on Dec 26, 2021Installed on Dec 29, 2021For: 2005 Hyundai XG350LIssue: Coolant Leaking From Hose at Old ClampSymptom: I had a noticeable leak at my radiator hose connection, near the original clamp. Parking area was getting wet from leaking coolant.First Review:Jan 14, 2022After replacing with these clamps, I was able to stop the leak. The band is stainless steel, but the worm drive is a different color and does not look like its stainless steel. Hardly rains in my neck of the woods so not too worried about that part getting contact with moisture. How long it will stay rust free, only time will tell.Helpful Hint: When I took the old clamp off and removed the hose, there was a lot of crud around the metal that the rubber hose goes over and inside the hose itself. Scraped and cleaned all that off and replaced with these. And no more leaks. Just in case, I used two clamps mounted in opposing directions to make sure I had good contact and proper seal.